Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Land Rover >> 2006 >> Range Rover HSE >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Anti-Lock Control - Traction Control) >> Anti-Lock Control - Traction Control >> Removal And Installation >> Rear Wheel Speed Sensor >> Removal

Rear Wheel Speed Sensor: Removal

WARNING: This page is about a different car, the 2009 Land Rover Range Rover, 2008 Land Rover Range Rover, and 2007 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Remove the wheel and tire.
  3. Release the wheel arch liner.
    • Remove the 5 screws.
    GJ0018737
  4. Disconnect the rear wheel speed sensor electrical connector.
    • Open the electrical connector housing.
    • Release the electrical connector from the clip.
    GJ0018738
  5. Remove the rear wheel speed sensor.
    • Release the wiring harness from the 5 clips.
    • Remove the bolt.
scientia non olet · About Mike's Workshop Manuals