Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Land Rover >> 2006 >> Range Rover HSE >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Anti-Lock Control - Traction Control) >> Anti-Lock Control - Traction Control >> Removal And Installation >> Anti-Lock Brake System (Abs) Module (Vehicles With: High Performance Brakes) >> Removal

Anti-Lock Brake System (Abs) Module (Vehicles With: High Performance Brakes): Removal

WARNING: This page is about a different car, the 2009 Land Rover Range Rover, 2008 Land Rover Range Rover, and 2007 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Make sure the ignition switch is in position 0.
NOTE: The hydraulic control unit (HCU) mounted to the ABS module cannot be serviced separately. If the HCU requires replacement, then the ABS module must be replaced as a complete assembly.
    WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
  1. Raise and support the vehicle.
  2. Disconnect the battery ground cable. Refer to Specifications .
  3. Disconnect the electrical connector.
    • Release the latch.
    • Reposition the electrical connector.
    GJ0018463
    4. CAUTION: Before disconnecting or removing the components, make sure the area around the joint faces and connections are clean. Plug open connections to prevent contamination.
    NOTE: Note the fitted position.
  4. Release the 6 brake fluid lines.
    • Position an absorbent cloth to collect fluid spillage.
    GJ0018464
  5. Remove the ABS module.
    • Loosen but do not remove the 2 nuts.
    • Release from the locating grommet.
    GJ0018465
scientia non olet · About Mike's Workshop Manuals