Anti-Lock Brake System (Abs) Module (Vehicles With: High Performance Brakes): Installation
WARNING: This page is about a different car, the 2009 Land Rover Range Rover, 2008 Land Rover Range Rover, and 2007 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
- Install the ABS module.
- Tighten the nuts to 8 Nm (6 lb.ft).
- Tighten the M10 and M12 unions to 15 Nm (11 lb.ft).
- Tighten the M14 union to 17 Nm (13 lb.ft).
- Connect the electrical connector.
- Secure the latch.
- Connect the battery ground cable. Refer to Specifications .
- Bleed the brake system. Refer to Brake System Bleeding - Vehicles With: High Performance Brakes .
NOTE:
Make sure the ABS module locating grommet is correctly seated in the bracket before installing the ABS module.
NOTE:
Make sure the ABS module locating pin is correctly located in the grommet, and the 2 isolators are fully seated in the bracket slots.