Abs Module

WARNING: This page is about a different car, the 2009 Land Rover Range Rover, 2008 Land Rover Range Rover, and 2007 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.

The anti-lock brake system (ABS) module controls the brake functions using the hydraulic control unit (HCU) to modulate hydraulic pressure to the individual wheel brakes.

The anti-lock brake system (ABS) module is attached to the hydraulic control unit (HCU), on the driver side inner fender in the engine compartment. A 46 pin connector provides the electrical interface between the anti-lock brake system (ABS) module and the vehicle wiring.

Courtesy of JAGUAR CARS, INC.

ABS MODULE HARNESS CONNECTOR C1585 PIN DETAILS

Pin No.	Description	Input/Output
1	Ground	Output
2	Battery power supply	Input
3	Battery power supply	Input
4	Ground	Output
5	Front left wheel speed sensor signal	Input
6	Rear left wheel speed sensor power supply	Output
7	Rear right wheel speed sensor power supply	Output
8	Rear right wheel speed sensor signal	Input
9	Front right wheel speed sensor power supply	Output
10	Front right wheel speed sensor signal	Input
11	Diagnostic ISO 9141 K line bus	Input/Output
12 and 13	Not used	-
14	High speed CAN bus low	Input/Output
15	Yaw rate and lateral acceleration sensor ground	Input
16	Yaw rate signal	Input
17	Not used	-
18	Yaw rate and lateral acceleration sensor reference	Input
19	Not used	-
20	Lateral acceleration signal	Input
21	Not used	-
22	Lighting Control Module (LCM)	Output
23 to 25	Not used	-
26	Front left wheel speed sensor power supply	Output
27	Rear left wheel speed sensor signal	Input
28	Ignition power supply	Input
29	Not used	-
30	Stoplamp switch	Input
31	DSC switch	Input
32	Not used	-
33	Road speed signal	Output
34	Not used	-
35	High speed CAN bus high	Input/Output
36	HDC switch	Input
37	Yaw rate and lateral acceleration sensor test	Output
38 to 40	Not used	-
41	Stoplamp switch	Input
42 to 46	Not used	-