Spark Plug Inspection
- Refer to
"SPARK PLUG
" and visually and/or physically inspect following conditions;
- Damaged insulation, worn electrodes, oil or fuel fouled, loose terminals and cracks.
- Measure the electrode gap.
Specification: Approx. 0.8 to 0.9 mm (0.0314 to 0.0354 in)
- Measure the insulation resistance with an multimeter.
Specification: Approx. 10MΩ or more
- Has any problems been found?
Good
- Go to "FUEL SYSTEM INSPECTION " procedure.
No Good
- Repair as necessary and than Go to "Verification Of Repair " procedure.