| DTC Strategy |
|
- Poor connection
- Rail pressure sensor
- ECM
|
| Enable Condition |
- No additional warm up fueling (ECT is greater than 73°C (163.4°F))
- Full load is not active (Gas pedal value is lower than 90%)
- Catalyst purge is not active
- Fuel trim is active
- Catalyst overheating prevention is not active (Catalyst model temperature is lower than 960°C (1760°F))
- Leak detection is not active
- Catalyst heating is finished
- Engine speed is between 512 RPM and 4000 RPM
- Mass fuel flow is between 0.012g/revolutions and 0.18g/revolutions
- Time after start is more than 15s
- Volume of fuel flow is less than 14.5 to 216 (l/h)
- Canister load is lower than 1.5
|
| Threshold Value |
- The average value from rail pressure sensor is out of range of threshold value (inappropriately high or low)
|
| Diagnostic Time |
|
| MIL ON Condition |
|