Visual check

Inspection Condition	Inspection Procedure	Reference
Ignition "OFF".	Check the installation condition. Check the connector for contamination, corrosion or damage. EV "ON". Check that the vehicle shifts and drives normally.	-

Good

Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
Go to "VERIFICATION OF REPAIR " procedure.

No Good

If no problems were found with the circuits or connectors, replace the SCU and go to "COMPONENT INSPECTION " procedure.
(After replacement, check the normal operation of each gear (P, R, N, D) by actually shifting the vehicle)