Circuit Inspection
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
|
HO2S (Bank 1, Sensor 1) connector | 2 (nernst voltage) | Chassis ground | - | 0V |
| HO2S (Bank 1, Sensor 1) connector | 1 (virtual ground) | Chassis ground | - | 0V | |
| HO2S (Bank1, Sensor1) connector | 3 (pumping current) | Chassis ground | - | 0V | |
| HO2S (Bank1, Sensor1) connector | 6 (trim resistor) | Chassis ground | - | 0V | |
|
HO2S (Bank1, Sensor1) connector | 2 (nernst voltage) | PCM connector | 59 (nernst voltage) | Approx. below 1Ω |
| HO2S (Bank1, Sensor1) connector | 1 (virtual ground) | PCM connector | 80 (virtual ground) | Approx. below 1Ω | |
| HO2S (Bank1, Sensor1) connector | 3 (pumping current) | PCM connector | 81 (pumping current) | Approx. below 1Ω | |
| HO2S (Bank1, Sensor1) connector | 6 (trim resistor) | PCM connector | 60 (trim resistor) | Approx. below 1Ω | |
Good
- Go to "COMPONENT INSPECTION " procedure.
No Good
- Repair or replace as necessary and then, Go to "VERIFICATION OF REPAIR " procedure.