Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2022 >> Stinger GT2, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Control System - 2.5L) >> Engine Coolant Temperature Sensor (ECTS) >> Repair Procedures >> Inspection >> Inspection component

Inspection component

WARNING: This page is about a different variant/trim than selected.
  1. Remove the Engine Coolant Temperature Sensor (ECTS).

    (Refer to Engine Coolant Temperature Sensor - "Removal  ")

  2. After immersing the thermistor of the sensor into engine coolant, measure resistance between ECTS signal terminal and ground terminal.
  3. Check that the resistance is within the specification.

Refer to "Specifications  "

scientia non olet · About Mike's Workshop Manuals