Major Features: Notes

Display Surrounding Area of Vehicle in Video
- The surrounding area video display function displays 360 degrees video image captured from four cameras on the Head Unit Screen while the vehicle is moving at low speed or reversing. The SVM System displays total 8 video modes for displaying surrounding video based on the vehicle driving state and the driver's selection.
Guide Line Indication & Steering Wheel Synchronized Feature
- The Guide Line Indication & Steering Wheel Synchronized Feature is the function that assists the driver in parking by synchronizing the steering wheel with the rear view video display marked with a guide line to help anticipate the direction of the reversing vehicle.
Front/Rear Object Warning (Obstacle Detection Feature)
- The system receives obstacle warning signal from the PDW sensors mounted on the front/rear of the vehicle and displays the obstacle location on the AVN Head Unit Screen.
Tolerance Compensation (including A/S)
- Manual Tolerance Compensation Software is embedded in the SVM ECM to compensate the SVM deviation that may occur due to assembly line installation tolerance. You must first setup proper work environment in order to perform correct tolerance compensation.
Rear-view display while driving
- The function displays the rear view even in N or D upon request of the driver. It provides an optimized image under driving condition unlike parking mode.
- In driving assist mode, each camera displays the fixed guidelines for 1 m, 3 m, and 10 m distances from the bumper on the distortion-corrected display with a viewing angle of approx. 110 degrees, and it also displays an icon at the upper right corner to indicate the vehicle's driving status along with a warning message.
- The conditions in driving assist mode are as follows:
  - The driving assist view button is touched on the screen during a stop.
  - The SVM switch is pressed while driving over 15 km/h (9.3 MPH).