Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2021 >> Sedona EX >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System Control Module (SRSCM) And Sensors >> Passive Occupant Detection System (PODS-F) >> Repair Procedures >> Installation >> PODS-F Mat

PODS-F Mat

  1. Install the PODS-F Mat equipped seat cushion assembly on the front seat assembly.

    (Refer to Body - "FRONT SEAT ")

  2. Connect the PODS-F mat connector.
  3. Install the front passenger seat assembly.

    (Refer to Body - "FRONT SEAT ")

  4. Reconnect the battery negative cable.
  5. After installing the PODS-F, confirm proper system operation:
    • Turn the ignition switch ON the SRS indicator should be turned on for about six seconds and then go off.
    • Telltale lamp will turn on for 4 seconds and then off for 3 seconds. After the 7 seconds, it shall remain off if the PODS-F does not require suppression and the passenger airbag is enabled.
NOTE: Be sure to perform PODS-F zeroing with KDS after replacing PODS-F equipped seat cushion.
scientia non olet · About Mike's Workshop Manuals