TPMS Inspection Method: Inspection
WARNING: This page is about a different car, the 2024 Kia K5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Find the inspection number by referring to the table above.
The following content is irrelevant of the inspection procedure.
The following content is irrelevant of the inspection procedure.
- Warning lamp types
- Keeps on without blinking: Low pressure tire warning lamp
- Flashes at 0.5 second intervals constantly: Initial state warning lamp
- Cluster blinks for 1 minute at 1 second intervals, then turns ON: Error code warning lamp
NOTE: Turn IG OFF and then IG ON again to check the warning light type. - Check the warning lamp state.
- Check the vehicle warning lamp state.
- Check if the warning lamp state is caused by tire low pressure.
Symptom: stays on without blinking
- Check the warning lamp state.
- Check the vehicle warning lamp state.
- Check if the warning lamp state is caused by the initial state (virgin mode) of TPMS receiver.
- Check the warning lamp state.
- Check the vehicle warning lamp state.
- Check if the warning lamp state is caused by error code (TPMS receiver and TPMS sensor failure). Symptom: blinks for 1 minute at 1 second intervals, then turns ON.
- Low tire pressure warning lamp
Cold: Vehicle kept for more than 60 minutes after stopping.
→ 0.07 kgf/cm2 (1.0 psi) additional air injection at the specified tire pressure.
Hot: Driven vehicle
→ 0.28 kgf/cm2 (4.0 psi) additional air injection at the specified tire pressure.
NOTE: In case the warning lamp fails to turn OFF after injecting tire pressure, disconnect the KDS and drive less than 1 km at 25 km/h. - Inspect initial state warning lamp
A. TPMS warning lamp
- Check the TPMS warning lamp status.
- Flashes at 0.5 second intervals constantly. -> Initial state warning lamp
NOTE: Turn IG OFF and then IG ON again to check the warning lamp type.B. (1) Enter sensor ID.
(Refer to " Wheel Sensor ID Writing ")
(2) Enter vehicle name.
(Refer to " Vehicle Name Writing ")
(3) Enter VIN.
(Refer to " Vehicle Name Writing ")
(4) Change TPMS ECU mode (to Standard mode).
- DTC checklist for performance test.
List symptoms Inspection items Detailed checklist Component/parts C1312(FL) C1313(FR)
C1314(RL)
C1315(RR)TPMS sensor receive error. Sensor RF transmission state Confirm sensor RF transmission Check sensor DTC Inspect sensor battery TPMS Sensor
Vehicle electronic units noise
Vehicle operating conditionsC1332(FL) C1333(FR)
C1334(RL)
C1335(RR)Sensor internal failure Inspect sensor RF transmission Sensor battery voltage Check sensor RF transmission Check sensor battery (KDS) TPMS Sensor C1662 Auto learning failure Sensor RF transmission state Inspect EMS vehicle speed (VS) Inspect vehicle noise Confirm sensor RF transmission Inspect sensor battery Inspect EMS vehicle speed (VS) Inspect vehicle electronic unit noise TPMS Sensor Vehicle electronic units noise Vehicle operating condition EMS vehicle speed signal C1663 Auto learning failure Sensor RF transmission state Inspect EMS vehicle speed (VS)Inspect vehicle noise Confirm sensor RF transmission Inspect sensor battery Inspect EMS vehicle speed (VS) Inspect vehicle electronic unit noise TPMS Sensor Vehicle electronic units noise Vehicle operating condition EMS vehicle speed signal NOTE:- Be sure to check DTC.
(Refer to " TIRE PRESSURE MONITORING SYSTEM (TPMS) DTCS " )
- If the TPMS warning light does not turn on: TPMS sensor periodically learns the sensor through driving.
- If the TPMS warning light turns on: Replace TPMS sensor, TPMS receiver.
- Be sure to check DTC.