Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2021 >> Forte GT Line >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Rear View Monitor Diagnosis) >> DTC B161F-00: Camera Input Error >> Component Inspection >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2024 Kia Forte. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition "OFF".
  2. Connect KDS.
  3. Ignition "ON".
  4. Select "Diagnostic Trouble Codes (DTCs)" mode.
  5. Using a KDS, Clear DTC.
  6. Operate the vehicle within DTC Detecting Condition in General Information.
  7. Select "Diagnostic Trouble Codes (DTCs)" mode again.
  8. Is the same DTC stored in the system?

    Good 

    • Fault might be intermittent and caused either by poor contact in connectors or not performing Parameter Setting and Zero Setting. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
    • Repair or replace as necessary and then Go to "VERIFICATION OF REPAIR " procedure.

    No Good 

    • Carefully re-do this troubleshooting guide steps.
    • If no problems were found with the circuits or connectors, replace the Rear Camera and Go to "VERIFICATION OF REPAIR " procedure.
scientia non olet · About Mike's Workshop Manuals