Component Inspection: Notes

Inspection Condition	Inspection Procedure	Reference
Ignition "OFF" Wait until the brake disc sufficiently gets cold (below 400°C (752°F).	Check the brake pads for wear and fade. Check the brake disc for damage and deformation. Check the brake tubes for cracks, crimps and corrosion. Check brake hose mounting bracket for crack or deformation.	-

Good

Carefully re-do this troubleshooting guide steps.
If no problems were found with the circuits or connectors, replace ESC module and then go to "VERIFICATION OF REPAIR " procedure.
* In case of replacing ESC control module, Perform "Vehicle S/W Management" procedure.

No Good

Repair or replace as necessary and then go to "VERIFICATION OF REPAIR " procedure.