Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2019 >> Soul EV Base >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Smart Key Code Saving Diagnosis >> DTC P1676: Immobilizer-Smartra Message Error >> DTC Inspection >> Monitor KDS Data >> Check VMCU Communication

Check VMCU Communication

  1. Ignition "ON" (Power Button LED "Red")
  2. Connect KDS and setup the oscilloscope.
  3. Back probe and measure signal waveform of Pin No. 15 (EMS COM) terminal of VMCU main harness connector and chassis ground by using VMI A channel.

    Specification  : Refer to Figure below

    G12813172Courtesy of KIA MOTORS AMERICA, INC.

    Figure) Communication signal waveform between SMK Unit and VMCU.

  4. Is the measured signal waveform normal?

    YES 

    • Fault is intermittent caused by poor contact in Smart Key unit and/or VMCU's connector or was repaired and Smart Key unit and memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About Mike's Workshop Manuals