Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2019 >> Soul Base, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (Antilock Brake System/Electronic Stability Control System Diagnosis) >> DTC C1503-01: TCS Switch Error >> DTC Inspection >> Monitor DTC Status

Monitor DTC Status

WARNING: This page is about a different car, the 2018 Hyundai Accent. However, it is still accessible from the selected car via links, so may be relevant.
  1. Plug GDS to Data Link Connector (DLC).
  2. Turn "ON" the ignition switch.
  3. Select "Diagnostic Trouble Codes (DTC)," and click "DTC Status" to check DTC information.
  4. Read the "DTC State" parameter.
    G12593399Courtesy of HYUNDAI MOTOR AMERICA
  5. Record all DTCs, DTC state and freeze frame data. Is the DTC State "Present?"
    NOTE:
    • History (Not Present) state: the DTC set but has been cleared.
    • Present state: the DTC is active at present time.

    YES 

    • Go to next procedure.

    NO 

    • Fault can be intermittent, caused by poor connection in "ESP OFF switch" line and/or ESP (ESC)'s connector. Or, IBAU memory was not cleared after it was repaired. Go to "Verification of Vehicle Repair " procedure.
scientia non olet · About Mike's Workshop Manuals