Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2019 >> Soul Base, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Motor Driven Power Steering System Diagnosis) >> DTC C1109-01: IGN Signal Error >> DTC Inspection >> Monitor GDS Data

Monitor GDS Data

WARNING: This page is about a different car, the 2018 Hyundai Accent. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect GDS to Data Link Connector (DLC).
  2. Start engine and turn the headlight and the heatwire on.
  3. Monitor the "BATTERY VOLTAGE" parameter on the GDS.
  4. Maintaining ENG. RPM at 2, 500 RPM (idle) over 2 minutes.

    Specification:  Battery Voltage

    G12592877Courtesy of HYUNDAI MOTOR AMERICA
  5. Is parameter within specifications?

    YES 

    • Fault is intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and EPS ECU memory is not cleared yet. Thoroughly check all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
    • Repair or replace as necessary and then go to "Verification of Vehicle Repair " procedure.

    NO 

scientia non olet · About Mike's Workshop Manuals