Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2019 >> Soul Base, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Engine Control System Diagnosis (1 Of 3)) >> DTC P0141-00: O2 Sensor Heater Circuit (Bank 1/Sensor 2) >> Component Inspection

Component Inspection

WARNING: This page is about a different car, the 2018 Hyundai Accent. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch "OFF" & Disconnect HO2S (S2) connector.
  2. Measure resistance between heater power and heater control terminal of HO2S (S2) (Component Side).

    Specification: 

    Trouble shooting Specification
    Heater Resistance (Ω) Approx. 9Ω at 20°C (68°F)
  3. Is the measured resistance within specification?

    YES 

    • Fault is intermittent caused by poor contact in the sensor's and/or ECM's connector. Or, ECM memory was not cleared after repair. Thoroughly check connectors for looseness, poor connection, ending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of Vehicle Repair ".

    NO 

    • Replace the HO2S (S2) with an usable one and check for proper operation. If the problem is corrected, replace the HO2S (S2) and then go to "Verification of Vehicle Repair ".
scientia non olet · About Mike's Workshop Manuals