Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2019 >> Sedona L >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Engine Control System) >> Variable Intake Solenoid (VIS) Valve >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different car, the 2020 Kia Sedona. However, it is still accessible from the selected car via links, so may be relevant.

[VIS #1] 

  1. Switch "OFF" the ignition and disconnect the negative (-) battery terminal.
  2. Disconnect the variable intake solenoid valve connector (A).
  3. Disconnect the vacuum hoses (B) from the valve.
  4. Remove the mounting nut (C) and then remove the valve from the surge tank.

    Variable intake solenoid valve mounting nut: 

    7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb.ft)

    G13044317Courtesy of KIA MOTORS AMERICA, INC.

[VIS #2] 

  1. Switch "OFF" the ignition and disconnect the negative (-) battery terminal.
  2. Disconnect the variable intake solenoid valve connector (A).
  3. Disconnect the vacuum hoses (B) from the valve.
  4. Remove the installation nuts (C) and then remove the valve from the surge tank.

    Variable intake solenoid valve mounting nut: 

    7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb.ft)

    G13044318Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals