Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2019 >> Optima EX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 211 (Surround View Monitor System Diagnosis (PHEV)) >> DTC B16BA-00: Right Camera Input Error >> Component Inspection

Component Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Ignition "OFF"
  2. Ignition "ON"
  3. Operate the SVMS switch.
  4. Monitor SVM display on head unit.
  5. Check location of camera that causes the problem.

    Specification:  Clear camera view is displayed on head unit.

    * Headunit screen displays blue screen if there is error in camera display output.

  6. Has problem been found?

    YES 

    • Carefully re-do this troubleshooting guide steps.
    • If no problems were found with the circuits or connectors, replace Ultra optical camera that causes the problem and then go to "VERIFICATION OF REPAIR " procedure.

    NO 

    • Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
    • Repair or replace as necessary and then go to "VERIFICATION OF REPAIR " procedure.
scientia non olet · About Mike's Workshop Manuals