Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2019 >> Optima EX >> Repair and Diagnosis >> External Pages >> Different car >> Section 146 (Blind Spot Detection System (HEV)) >> Blind Spot Detection Unit >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different car, the 2018 Kia Optima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the RH and LH radar sensors on each side to get ready for installation.
  2. Install the radar sensor to the bracket correctly (distinguish RH & LH) with mounting screws.
    CAUTION:
    • The shapes of the LH and RH blind spot detection units are different. Therefore, take notice when installing the blind spot detection units.
    • Radar Sensors must be closed up against the bracket completely.
    • After mounting radar sensors, check for looseness.
  3. Install the rear bumper cover.
  4. Connect the negative (-) battery terminal.
scientia non olet · About Mike's Workshop Manuals