Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2019 >> Niro Plug-In Hybrid EX >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (Airbag Modules And Clock Spring (PHEV)) >> Curtain Airbag (CAB) Module >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different car, the 2018 Hyundai Ioniq. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable and wait for at least three minutes.
  3. Tighten the curtain airbag mounting bolts and nuts.

    Tightening torque: 

    Bolt: 7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)

    CAUTION:
    • Never twist the airbag module during installation. If the airbag module is twisted, the airbag module may operate abnormally.
  4. Connect the curtain airbag connector.
  5. Install the roof trim.

    (Refer to "ROOF TRIM ASSEMBLY ")

  6. Reconnect the battery negative cable.
  7. After installing the curtain airbag (CAB), confirm proper system operation:
    • Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
scientia non olet · About Mike's Workshop Manuals