Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2019 >> Niro FE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 31 (Airbag Modules And Clock Spring (PHEV)) >> Knee Airbag (KAB) Module >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the battery negative cable, and wait for at least three minutes before beginning to work.
  2. Install the knee air bag.

    Tightening torque 

    Bolts: 7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb.ft)

  3. Install the crash pad lower panel.

    (Refer to "CRASH PAD LOWER PANEL ")

  4. Reconnect the battery negative cable.
  5. After installing the knee air bag (KAB), confirm proper system operation:
    • Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
scientia non olet · About Mike's Workshop Manuals