Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2019 >> Niro FE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 31 (Airbag Modules And Clock Spring (PHEV)) >> Curtain Airbag (CAB) Module >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the battery negative terminal, and wait for at least three minutes before beginning to work.
  2. Install the curtain airbag and then loosen the bolts and nuts.

    Tightening torque 

    7.8 - 11.7 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)

    CAUTION: Never twist the airbag module when installing it. If the module is twisted, airbag module may operate abnormally.
  3. Connect the curtain airbag connector.
  4. Install the roof trim.

    (Refer to " ROOF TRIM ASSEMBLY  ") 

  5. Reconnect the battery negative terminal.
  6. After installing the curtain airbag (CAB), confirm proper system operation:
    • Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
      NOTE: Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off
scientia non olet · About Mike's Workshop Manuals