Monitor KDS Data

WARNING: This page is about a different variant/trim than selected.

Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Ignition "ON"	SMK	6 (EMS COM)	Chassis ground	-	Fig 1

Fig 1: Screen Display - Communication Signal Waveform Between SMK Unit And ECM

Courtesy of KIA MOTORS AMERICA, INC.

Good

Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
Repair or replace as necessary and go to "VERIFICATION OF REPAIR " procedure.

No Good

SMK STATUS INFORMATION

Inspection Condition	Inspection Procedure	Reference
Ignition "ON", engine "OFF"	Connect KDS to Data Link Connector (DLC). Perform "Vehicle S/W Management" of concerned component with KDS.	Fig 2 to Fig 3

Fig 2: Screen Display - Select SMK Status Information In Vehicle S/W Management

Courtesy of KIA MOTORS AMERICA, INC.

Fig 3: Screen Display - Displays Number Of Registered Key And Learning Status

Courtesy of KIA MOTORS AMERICA, INC.

Good

Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
Repair or replace as necessary and go to "VERIFICATION OF REPAIR " procedure.

No Good