Check Oil Pressure Control Valve Operating State
- Ignition "OFF".
- Disconnect the Oil Pressure Solenoid Valve connector.
- Apply power to Pin No. 1 (power) and connect ground to Pin No. 2 (control) terminal of Oil Pressure Solenoid Valve. (component side)
- Specification:
Operating sound is heard
Good
- Fault is intermittent caused by poor contact in the sensor's and/or ECM's connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF REPAIR " procedure.
No Good
- Carefully re-do this troubleshooting guide steps.
- If no problems were found with the circuits or connectors, replace the Oil Pressure Solenoid Valve and go to "VERIFICATION OF REPAIR " procedure.