Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2018 >> Stinger Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Control System - 3.3L) >> Rail Pressure Sensor (RPS) >> Repair Procedures >> Inspection

Repair Procedures: Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Connect the KDS on the Data Link Connector (DLC).
  2. Measure the output voltage of the RPS at idle and various engine speed.
    Pressure Output Voltage (V) [Vref=5V]
    bar [MPa (kgf/cm2 , psi)]
    0 0 (0, 0) 0.5
    140 14(142, 2031) 2.5
    280 28 (286, 4061) 4.5
scientia non olet · About Mike's Workshop Manuals