Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2018 >> Stinger Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Control System - 3.3L) >> Fuel Tank Pressure Sensor (FTPS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Switch "OFF" the ignition and disconnect the negative (-) battery terminal.
  2. Remove the rear seat cushion.

    (Refer to Body - "REAR SEAT ASSEMBLY ")

  3. Remove the sub fuel sender service cover (A) after loosening the mounting screws.
    G12803540Courtesy of KIA MOTORS AMERICA, INC.
  4. Disconnect the fuel tank pressure sensor connector (A).
  5. Remove the fuel tank pressure sensor (B) after releasing the hooks vertically.
    G12803541Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals