Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2018 >> Stinger Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Control System - 3.3L) >> ETC (Electronic Throttle Control) System >> Repair Procedures >> Cleaning

Repair Procedures: Cleaning

WARNING: This page is about a different variant/trim than selected.
  1. Remove the ETC Module.

    (Refer to Engine Control System - " ETC SYSTEM  ") 

  2. Keep the ETC module plate (A) open.
    G12803468Courtesy of KIA MOTORS AMERICA, INC.
  3. Lean the pollutant in the throttle body with a soft cloth moistened with cleaning fluid.
    G12803469Courtesy of KIA MOTORS AMERICA, INC.
    NOTE:
    • Do not spray cleaning fluid directly onto ETC. Use a lint free cloth moistened with cleaning fluid.
    • Be careful not to clean the coating fluid around the shaft. If coating fluid is removed, idling control failure might occur by foreign substance inflow or excessive air leakage.
  4. After cleaning, re-install the ETC module and then perform the ETC module learning procedure.

    (Refer to Engine Control System - " ETC SYSTEM  " - Adjustment) 

scientia non olet · About Mike's Workshop Manuals