Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2018 >> Sedona L >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Engine Control System) >> Intake Air Temperature Sensor (IATS) >> Repair procedures >> Removal

Repair procedures: Removal

WARNING: This page is about a different car, the 2018 Kia Cadenza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Switch "OFF" the ignition and disconnect the negative (-) battery terminal.
  2. Disconnect the vacuum hose (A).
  3. Disconnect the intake temperature sensor connector (B).
  4. Remove the sensor after loosening the mounting bolt.

    Intake Air Temperature Sensor (IATS) mounting bolt  :

    9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb.ft)

Fig 1: Disconnecting Intake Temperature Sensor Connector
G12290687Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals