Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2018 >> Sedona L >> Repair and Diagnosis >> External Pages >> Different car >> Section 85 (Supplemental Restraint System Control Module (SRSCM) & Sensors) >> SRS Control Module (SRSCM) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different car, the 2018 Kia Cadenza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery negative terminal and wait for at least thirty seconds before beginning work.
  2. Remove the floor console.

    (Refer to Body (Interior and Exterior) - "FLOOR CONSOLE ")

  3. Disconnect the Supplemental Restraint System Control Module (SRSCM) connector (A).
    Fig 1: Locating Supplemental Restraint System Control Module Connector
    G12294320Courtesy of KIA MOTORS AMERICA, INC.
  4. Loosen the bolt and nuts and then remove the Supplemental Restraint System Control Module (SRSCM).
    CAUTION: You must remove or install SRSCM or other SRS components with the ignition switch OFF to avoid accidental airbag deployment.
    Fig 2: Locating Supplemental Restraint System Control Module Bolt & Nuts
    G12294321Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals