Repair Procedures: Removal

WARNING: This page is about a different car, the 2018 Kia Cadenza. However, it is still accessible from the selected car via links, so may be relevant.

Remove the front wheel and tire (A) from front hub.
Tightening torque:

88.2 - 107.8 N.m (9.0 - 11.0 kgf.m, 65.0 - 79.5 lb.ft)

Fig 1: Locating Front Wheel & Tire
Courtesy of KIA MOTORS AMERICA, INC.

NOTE: Be careful not to damage the hub bolts when removing the wheel & tire (A).
Remove the wheel speed sensor (A) from the knuckle.
Tightening torque:

8.8 - 13.7 N.m (0.9 - 1.4 kgf.m, 6.5 - 10.1 lb.ft)

Fig 2: Locating Wheel Speed Sensor
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the wheel speed sensor.
Loosen the bolt (A) and then remove the bracket.

Fig 3: Locating Wheel Speed Sensor & Bracket Bolt
Courtesy of KIA MOTORS AMERICA, INC.
Remove the front wheel guard.
(Refer to body - "FRONT WHEEL GUARD ")
Disconnect the front wheel speed sensor connector (A).

Fig 4: Locating Front Wheel Speed Sensor Connector
Courtesy of KIA MOTORS AMERICA, INC.
Install in the reverse order of removal.