Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2018 >> Sedona EX >> Repair and Diagnosis >> External Pages >> Different car >> Section 145 (Audio/Video/Navigation (AVN) System) >> AVN Monitor >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different car, the 2018 Kia Cadenza. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
  • When removing the interior trim pieces, use a plastic panel removal tool to prevent damaging the surface.
  1. Disconnect the negative (-) battery terminal.
  2. Remove the center fascia upper panel.

    (Refer to Body - "CENTER FASCIA PANEL ")

  3. Remove the AVN monitor (A) after loosening the screws.
    Fig 1: Locating AVN Monitor With Screws
    G12297278Courtesy of KIA MOTORS AMERICA, INC.
  4. Disconnect the AVN monitor connectors (A).
    Fig 2: Locating AVN Monitor Connectors
    G12297279Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals