Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2018 >> Optima Plug-In Hybrid EX >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Engine Control System (PHEV)) >> Intake Air Temperature Sensor (IATS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different car, the 2017 Kia Optima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the manifold absolute pressure sensor connector (A).
  3. Remove the installation bolt (B), and then remove the sensor from the surge tank.

    Intake Air Temperature Sensor (IATS) mounting bolt: 

    9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb.ft)

    G12347270
scientia non olet · About Mike's Workshop Manuals