Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2018 >> Optima Plug-In Hybrid EX >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Engine Control System (PHEV)) >> Crankshaft Position Sensor (CKPS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different car, the 2017 Kia Optima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) termnial.
  2. Remove the engine room under cover.

    (Refer to Engine Mechanical System - "ENGINE ROOM UNDER COVER ")

  3. Disconnect the crankshaft position sensor connector (A) and remove the sensor (B) after removing the installation bolt.

    Crankshaft position sensor installation bolt: 

    7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb.ft)

G12347278
G12347279
scientia non olet · About Mike's Workshop Manuals