Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2018 >> Niro Touring Graphite Edition >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis (6 Of 6) (HEV) >> DTC U05A0-00: Invalid Data Received From Evaporative Emission System Leak Detection Control Module >> DTC Inspection >> Monitor DTC Status

Monitor DTC Status

Inspection Condition Inspection Procedure Reference
  1. Ignition "ON".
  1. Connect KDS/GDS to Data Link Connector (DLC).
  2. Monitor "Diagnostic Trouble Codes (DTC)" with GDS/KDS.
 -
Active Fault 
  • Go to "Wiring Inspection" procedure below
History/Pending Fault 
  • Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage. Repair or replace as necessary and then go to "VERIFICATION OF REPAIR " procedure.
scientia non olet · About Mike's Workshop Manuals