Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2018 >> Forte S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Control System - 2.0L GDI) >> Variable Intake Solenoid (VIS) Valve >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
  2. Disconnect the variable intake solenoid valve connector (A).
  3. Disconnect the vacuum hoses (B) from the valve.
  4. Remove the installation nut, and then remove the valve from the surge tank.
Fig 1: Disconnecting Variable Intake Solenoid Valve Connector
G12162522Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals