Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2018 >> Forte LX, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Control System - 2.0L GDI) >> Purge Control Solenoid Valve (PCSV) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
  2. Disconnect the purge control solenoid valve connector (A).
  3. Disconnect the vapor hoses (B) from the purge control solenoid valve.
  4. Remove the valve (C) from the surge tank after pulling it.
Fig 1: Disconnecting Purge Control Solenoid Valve Connector
G12162505Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals