Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2017 >> Soul Base, Standard Trans >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System Control Module (SRSCM) And Sensors >> Side Impact Sensor (SIS) >> Repair Procedures >> Removal >> Side Impact Sensor

Side Impact Sensor

  1. Disconnect the battery negative cable and wait for at least three minutes before beginning work.
  2. To remove the emergency fastening device (C), keep on pushing the lock pin (A) as arrow direction. And then remove the seat belt after pushing the lock pin (B).
    Fig 1: Removing Emergency Fastening Device
    G12229590Courtesy of KIA MOTORS AMERICA, INC.
  3. Remove the center pillar lower trim.

    (Refer to Body - "CENTER PILLAR TRIM ")

  4. Disconnect the side impact sensor connector (A).
    Fig 2: Locating Side Impact Sensor And Connector
    G12229591Courtesy of KIA MOTORS AMERICA, INC.
  5. Loosen the side impact sensor mounting bolt and then remove the side impact sensor (B).
scientia non olet · About Mike's Workshop Manuals