Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2017 >> Soul Base, Automatic Trans >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System Control Module (SRSCM) And Sensors >> Side Impact Sensor (SIS) >> Repair Procedures >> Removal >> Pressure Side Impact Sensor

Pressure Side Impact Sensor

CAUTION:
  • Removal of the airbag must be performed according to the precautions/procedures described previously.
  • Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).
  • Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
  1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
  2. Remove the front door trim.

    (Refer to Body - "FRONT DOOR TRIM ")

  3. Disconnect the pressure side impact sensor connector (A) and remove the pressure side impact sensor mounting screws (B).
    Fig 1: Locating Pressure Side Impact Sensor Connector And Mounting Screws
    G12229589Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals