Control Circuit Inspection
- Ignition "OFF"
- Disconnect FPR connector.
- Ignition "ON" & ENG "OFF"
- Measure voltage between Pin No. 1 (Low Control), Pin No. 2 (High Control) terminal of FPR harness connector and chassis ground.
Specification : FPR Low Terminal: Approx. 0V
FPR High Terminal: Approx. 0.8V
- Is the measured voltage within specification?
YES
- Go to "Component Inspection " procedure.
NO
- Repair or replace as necessary and then, go to "Verification Of Repair " procedure.