Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2017 >> Sorento SX, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Control System - 2.4L) >> Engine Coolant Temperature Sensor (ECTS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
  2. Remove the air cleaner.

    (Refer to Engine Mechanical System - "AIR CLEANER ")

  3. Disconnect the engine coolant temperature sensor connector (A).
    Fig 1: Disconnecting Engine Coolant Temperature Sensor Connector
    G12180214Courtesy of KIA MOTORS AMERICA, INC.
  4. Remove the spring clip (A), and then pull the sensor from the water temperature control assembly.
    CAUTION: Note that engine coolant may flow out of the water temperature control assembly when removing the sensor.
    Fig 2: Locating Spring Clip
    G12180215Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals