Repair Procedures: Installation
WARNING: This page is about a different variant/trim than selected.
NOTE:
- Install the component to the specified torques.
- Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
- Apply the engine oil to the O-ring.
- Insert the sensor in the installation hole and be careful not to damage sensor when installing.
- Install in the reverse order of removal.
Crankshaft position sensor mounting bolt :
6.9 ~ 9.8 N.m (0.7 ~ 1.0 kgf.m, 5.1 ~ 7.2 lb-ft)