Control Circuit Inspection
- IG "OFF" & Disconnect OCV#1 (Intake) connector.
- IG "ON".
- Measure voltage between Pin No. 2 (Control) terminal of OCV#1 (Intake) harness connector and chassis ground.
Specification : Approx. 3.5V
- IG "OFF" & Disconnect PCM connector.
- Measure resistance between Pin No. 2 (Control) terminal of OCV#1 (Intake) harness connector and chassis ground.
Specification : ∞ (Infinity)Ω
- Is the measured Value within specification?
YES
- Go to "COMPONENT INSPECTION " procedure.
NO
- Repair or replace as necessary and then, go to "Verification Of VEHICLE REPAIR " procedure.