ECM Neutral Mode Procedure (With Immobilizer)

After replacing the ECM of the vehicle with the immobilizer, the following procedure must be performed.
[If installing a used ECM]
1. Perform "ECM Neutral Mode" procedure using KDS/GDS.
  (Refer to Body Electrical System - "Immobilizer System - REPAIR PROCEDURES ")
2. After finishing "ECM Neutral Mode", perform TEACHING PROCEDURES using KDS/GDS.
  (Refer to Body Electrical System - "Immobilizer System - REPAIR PROCEDURES ")
  
  [If installing a new ECM]
  
  Perform TEACHING PROCEDURES using KDS/GDS.
  
  (Refer to Body Electrical System - "Immobilizer System - REPAIR PROCEDURES ")