Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2017 >> Optima Plug-In Hybrid EX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 51 (Multi Function Camera Diagnosis (Except HEV)) >> DTC C1672-86: SAS Message Counter Error >> Component Inspection

Component Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Ignition "OFF"
  2. Connect KDS/GDS to Data Link Connector (DLC).
  3. Ignition "ON"
  4. Monitor "Diagnostic Trouble Codes (DTC)  " with KDS/GDS.
  5. Clear any DTCs stored in the system with KDS/GDS.
  6. Re-check DTC in the system with KDS/GDS.
  7. Did the same DTC is stored in the system?

    YES 

    • Carefully re-do this troubleshooting guide steps.
    • If no problems were found with the circuits or connectors, replace SAS and then go to "Verification of Vehicle Repair " procedure.

    NO 

    • Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
    • Repair or replace as necessary and then go to "Verification of Vehicle Repair " procedure.
scientia non olet · About Mike's Workshop Manuals