Repair Procedures: Installation
WARNING: This page is about a different variant/trim than selected.
NOTE:
- Tighten the component with the specified torques.
- If the component has been dropped, inspect if it is damaged before installation.
- Apply the engine oil to the O-ring.
- Insert the sensor in the installation hole and be careful not to damage.
- Install in the reverse order of removal.
Crankshaft position sensor mounting bolt:
7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb.ft)