Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2017 >> Optima EX >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Supplemental Restraint System Control Module (SRSCM) And Sensors (Except HEV)) >> SRS Control Module (SRSCM) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different car, the 2018 Kia Optima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the Ignition from the vehicle.
  2. Disconnect the battery negative cable and wait for at least thirty seconds before beginning work.
  3. Remove the floor console.

    (Refer to Body (Interior and Exterior) - "FLOOR CONSOLE ")

  4. Disconnect the Supplemental Restraint System Control Module (SRSCM) connector (A).
    Fig 1: Locating Supplemental Restraint System Control Module Connector
    G12141966Courtesy of KIA MOTORS AMERICA, INC.
  5. Loosen the nuts (A) and bolt (B) and then remove the Supplemental Restraint System Control Module (SRSCM).
Fig 2: Locating Supplemental Restraint System Control Module Nuts And Bolt
G12141967Courtesy of KIA MOTORS AMERICA, INC.
CAUTION: You must remove or install SRSCM or other SRS components with the ignition switch OFF to avoid accidental airbag deployment.
scientia non olet · About Mike's Workshop Manuals