DTC Information: DTC Detecting Condition

Item		Detecting Condition	Possible Cause
DTC Strategy	Case 1	O2 sensor controller malfunction	Poor connection or damaged harness Unstable Power Faulty PCM
	Case 2	Knock acquisition check
	Case 3	Power stage Port Flap Driver over temperature
	Case 4	H-bridge (ETC, Port Flap) malfunction
	Case 5	Output driver malfunction
	Case 6	Power Relay driver malfunction
	Case 7	5V power supply driver malfunction
Enable Conditions	Case 1	Ignition "ON" Battery voltage is between 10V and 16V
	Case 2	Engine speed is higher than 32 rpm
	Case 3	Battery voltage is between 10V and 16V Engine speed is higher than 32 rpm
	Case 4	Ignition "ON"
	Case 5	Ignition "ON"
	Case 6	Ignition "ON"
	Case 7	Ignition "ON"
Threshold Value	Case 1	Error bit information from H/W circuit
	Case 2	Integrity of the knock acquisition is not correct
	Case 3	Power stage output for Port Flap has over temperature
	Case 4	Microcontroller communication error is detected
	Case 5	Microcontroller communication error is detected
	Case 6	Microcontroller communication error is detected
	Case 7	Microcontroller communication error is detected
Diagnostic Time	Case 1	5s
	Case 2	200 revs
	Case 3	0.4s
	Case 4	1s
	Case 5	1s
	Case 6	1s
	Case 7	1s
MIL ON Condition		2 driving cycles