Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2017 >> Forte LX, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis - 2.0L MPI Nu (2 Of 3) >> DTC P050A: Cold Start Idle Air Control System Performance >> System Inspection

System Inspection

■ Check intake system for blockage 

  1. Visually/physically inspect the following items:
    • Air cleaner filter element for excessive dirt or for any foreign objects.
    • Hoses of intake system for blockage.
    • Throttle body inlet for damage or for any foreign objects.
    • Throttle plate for carbon deposits.
  2. Has a problem been found in any of the above areas?

    YES 

    NO 

    • Go to "Perform ETC Motor Actuation Test" procedure.

■ Perform ETC Motor Actuation Test 

  1. Connect KDS/GDS to Data Link Connector (DLC).
  2. Ignition "ON" & Engine "OFF".
  3. Perform "Actuation Test" for "ETC Motor".
Fig 1: Screen Display - ETC Motor Actuation Test
G12151854Courtesy of KIA MOTORS AMERICA, INC.

■ Inspect ETC Motor 

  1. Ignition "OFF".
  2. Disconnect ETC Motor connector.
  3. Measure resistance between power and control terminal of the ETC Motor. (Component Side)

    Specification  : Approx. 0.3 to 100Ω [20°C (68°F)]

■ Confirm Part Inspection 

  1. Does the ETC Motor operate properly? (Check variation)

    YES 

    NO 

    • Carefully re-do this troubleshooting guide steps.
    • If the diagnostics have been performed correctly with no failure found, replace the ETC and then go to "Verification of Vehicle Repair " procedure.